Original 8 x AA battery holder with 5.5mm/2.1020mm Plug and On/Off Switch – PartsCountry

Description

For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). This plug-n-play pot comes with a JST-PH 2mm connector and a matchingJST PH 3-Pin to Male Header Cables – 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you’re using a 5V Arduino or compatible, connect red to 5V. If you’re using a 3V Feather board, tie red to 3V.

If you want to connect to something with alligator clips use our STEMMA to Gator cable. To connect to something with a STEMMA 3-pin connector already, use this cable.

Technical Details

• PCB Dimensions: 28mm x 21mm
• Potentiometer (L x W x H): 11.8mm x 10mm x 20mm

• PCB Diagram
• Pinout